Posted on

How to apply Rass-O’-Nil Rust Preventive

The method of applying Rass-O’-Nil® conductive rust preventive on HR and CRCA metal. It is very important to clean and prepare the metal surface properly for better passivation.

Rass-O’-Nil application method for fresh steel:

Step 1: Remove all foreign matter – grit, dirt, cement particles, carbon particles, primer etc by brush. Dust off the loose particles. Wipe the metal surface with a clean cloth.
Step 2: After cleaning the metal surface, mop the metal with a medium density foam roller/section dipped in Rass-O’-Nil to evenly thin film the metal surface. The surface should not be made very wet because this is a nano-coat and excess liquid will be wasted. When the metal surface is dry to touch it can stored for future use.

Points to note:
i) Wear rubber gloves during surface preparation and coating Rass-O’-Nil G.
ii) During spray application the operator must wear glasses to protect the eyes.
iii) Rass-O’-Nil has no instant effect on the skin but wash exposed skin with water
after using Rass-O’-Nil.
iv) Rass-O’-Nil is not inflammable and is not combustible. Store Rass-O’-Nil in a sealed container. Do not add water to Rass-O’-Nil. This will damage the material.

Rass-O’-Nil is a registered trademark of Roy Research and Technology.

Leave a Reply

Your email address will not be published. Required fields are marked *